piwik image

Call Us: 800-580-5588

MENU

Products

Contact

Locations

Resources

Services

About

Purvis Industries

INA HK1520-2RS-L271
INA

INA HK1520-2RS-L271

loading
INA
Email Print

HK1520-2RS-L271

INA HK1520-2RS-L271 HK Series Drawn Cup Needle Roller Bearing With Open End, 15 mm Dia Bore, 21 mm OD, 1 Rows, 20 mm W, 10500 N Load

  • Item#: HK1520-2RS
  • Mfr#: HK1520-2RS-L271
  • UPC: 03537306272
  • The bearings are particularly suitable for applications with a very small radial section height on account of their very low cross-sectional height
  • Used if the housing bore is not suitable as a raceway for needle roller and cage assemblies
  • Can support high radial loads
  • Require a considerably smaller radial design envelope than machined needle roller bearings
  • Usually run directly on the shaft
  • Permit relatively high speeds
  • Easy to mount
  • Require no additional means of axial retention
  • Can be readily used to close off the shaft ends of bearing positions
  • Result in particularly compact, cost-effective and economical bearing arrangements
  • Contact seal on both sides
  • L271 anti wear protection grease
  • 10500 N dynamic/14400 N static
  • Min. Order Qty: 1
  • Qty. Interval: 1
  • loading

DESCRIPTION

Drawn cup needle roller bearings with open ends are supplied with a needle roller and cage assembly or a full complement needle roller set. Bearings with needle roller and cage assemblies allow higher speeds than the full complement designs.

INA Drawn Cup Needle Roller Bearing, Series: HK Series, 15 mm Bore, 21 mm OD, 1 Rows, 20 mm Width, Double Seal Closure, 10500 N Load, Sheet Steel Cage, 9900 rpm Maximum, -20 to 100 deg C

SPECIFICATIONS

Series      :      HK Series
Load Capacity      :      10500 N
Maximum Speed      :      9900 rpm
Outside Diameter      :      21 mm
Number of Rows      :      1
Width      :      20 mm

DOCUMENTS